Selection of dredging hoses: 5 key parameters to consider

Nov 04, 2026

View: 9

Leave a message

When many engineering projects select hoses, they only look at the inner diameter. Later, problems such as burst pipes, short lifespan, and insufficient flow may occur. When selecting,
you should simultaneously confirm the following 5 parameters:

1. Working pressure + negative pressure grade: Differentiate between only slurry discharge and suction discharge. The deeper the suction, the higher the requirements for vacuum negative pressure indicators;
2. Transport medium: Ordinary mud and sand, mineral slurries with crushed stones, seawater, weakly corrosive chemical media, corresponding inner liner rubber formulations are completely different;
3. Diameter and length: Match the pipe diameter according to the pump flow rate. The length should reserve bending allowance and installation must not be forcibly pulled;
4. Flange standard: GB national standard, ANSI American standard, DIN German standard. For foreign trade orders, the flange hole distance and pressure grade must be confirmed in advance;
5. Operating temperature: Common rubber is applicable from -20℃ to 40℃. Special rubber materials need to be customized for high-temperature or extremely cold working conditions.

Provide the working conditions to the manufacturer before selection, and let the technicians calculate and match. This is more reliable than blind procurement.
Send Inquiry